Filter
Top Products
404
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Max Number of
Routes per Cache
Sets the number of calls that can pass between a specific source and any
destination node that has previously been accessed using the same route.
After this number of calls, the cache will be refreshed. The default
number of calls is 40. A change to the number of calls takes place
immediately.
Command Actions
Command Result
Example
Enter:
1 1 9 4 6 6 50
The following message is displayed:
Num of calls to refresh the DTL cache is 50
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(6) SMN: Set Max Number of Routes
per Cache
Enter a parameter at the prompt
Parameter
Format or Range
Num of Calls
1 - 1000
Direct access sequence:
1 1 9 4 6 6
[parameters]
System action taken:
The number of calls that can pass between a specific
source and any destination node using the same route
is updated.
System message display:
Num of calls to refresh the DTL cache
is <n>