Filter
Top Products
ILMI Setup
117
Update
Auto-discovery status
Enable or disable the auto-discovery status for the specified port of the
CoreBuilder 9000 ATM Enterprise Switch. Auto-discovery determines, by
negotiation, the common protocol parameters, ATM interface type and
IME type to be used by the ILMI channel. The status can be either enabled
or disabled. For more information about auto-discovery, see
“Auto-Discovery” on page 57 in the Operations Guide.
Command Actions
Command Result
Example
Enter:
1 1 8 2 1 3.1.2
The following message is displayed:
Auto-Discovery is ENABLED.
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(8) IME: ILMI Setup
(3) AUD: Auto-Discovery Setup
(2) SET: Set & Save Auto-Discovery
ON/OFF Status
Enter a parameter at the prompt
Parameter Format or Range
Port ID <slot.group.port> or
0.0
for all ports
Auto-discovery
enable/disable
0
to disable auto-discovery
1
to enable auto-discovery
Direct access sequence:
1 1 8 2 1
[parameters]
System action taken:
The auto-discovery status is updated for the selected
port immediately and is saved in flash.
System message display:
Auto-Discovery is <ENABLED/DISABLED>.