Filter
Top Products
Configuring the Route Cache
399
Configuring the
Route Cache
The following commands allow you to set up the route cache parameters.
Get Cache State
Set Cache State
Get Cache Refresh for ADD PARTY
Set Cache State for ADD PARTY
Get Max Number of Routes per Cache
Set Max Number of Routes per Cache
Get Cache State
Display the current DTL cache state. The DTL cache state may be
ENABLED or DISABLED. The default cache state is ENABLED.
Command Actions
Command Result
Example
Enter:
1 1 9 4 6 1
The following message is displayed:
PNNI Cache (for UBR) is ENABLED.
Press ENTER to continue....
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(1) GCS: Get Cache State
Direct access sequence:
1 1 9 4 6 1
System action taken:
The current DTL cache state is displayed.
System message display:
PNNI Cache (for UBR) is
ENABLED/DISABLED.
Press ENTER to continue....