Filter
Top Products
Setting the Timers
359
Set Hello Interval
Sets the Hello interval value. In the absence of triggered Hellos, the
specified node will send one Hello packet on each of its ports every
“interval” seconds. A change to the Hello interval value takes place after
the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 4 3 5
The following message is displayed:
Default Value is 15 (15 sec), new value is 5
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(3) HIN: Hello Interval
Enter a parameter at the prompt
Parameter
Format or Range
interval 1 - 30000 seconds
Direct access sequence:
1 1 9 4 3 4 3
[parameters]
System action taken:
The Hello holddown timer values is displayed and is
updated to its new value.
System message display:
Default value is <x>, new value is <y>