Filter
Top Products
86
C
HAPTER
5: C
ONFIGURING
THE
P
LATFORM
Managing Switch
Fabric Modules
You can display Switch Fabric Module information for the
CoreBuilder 9000 ATM Enterprise Switch.
Display Switch Fabric Module Status
Reset Switch
Reset Standby Switch Fabric Module
Set Standby Switch Fabric Module to Suspended/ In-service Mode
Upgrade Software Files
Display Switch Fabric
Module Status
Display information about each of the switch fabric modules present. If
there are two switch fabric modules, one is used for standby. See the
CoreBuilder 9000 Switch Fabric Module Getting Started Guide
for more
information about standby Switch Fabric Modules.
Command Actions
Command Result
Example
Enter:
1 4 1
ATM Switch Fabric Module information is displayed:
Enter the menu sequence:
(1) SYS: Platform configuration
(4) SWM: Switch modules
(1) DSS: Display Switch status
Direct access sequence:
1 4 1
System action taken:
CoreBuilder 9000 ATM Switch Fabric Module
information is displayed.
System message display:
Information is displayed as shown in the example.
Slot id Slot status Switch type Switch mode Memory size
------- ------------ ---------------- ------------ ------------
*
* 8 Occupied 22x22 ATM switch Active 64 MB
9 Occupied 22x22 ATM switch In-Srv STBY 64 MB
S
Switch MAC address: 00.c0.da.7f.92.29
w
Switch sys up time: 0 day(s), 00:38:11