Filter
Top Products
92
C
HAPTER
5: C
ONFIGURING
THE
P
LATFORM
Configuring
Interface Modules
You can configure parameters for the interface modules of the
CoreBuilder 9000 ATM Enterprise Switch.
Display Interface Module Information and Parameters
Set Port Frame Mode
Set Port Clock Mode
Set Loop Mode
Reset Interface Card
Display Interface
Module Information
and Parameters
Display the slot ID, slot status, and card type of each of the 11 interface
modules or display parameters of an installed interface module. You are
prompted to specify an interface module for display.
Command Actions
Command Result
Enter the menu sequence:
(1) SYS: Platform configuration
(5) IFC: Interface cards
(1) GIF: Get interface card info
Enter a parameter at the prompt
Parameter Format or Range
Slot ID 1 through 6 in the 7-slot chassis and 8-slot chassis and
1 through 7, 10, 12, 14, and 16 in the 16-slot chassis
for interface card information or 0 for general slot
information.
Direct access sequence:
1 5 1
[parameters]
System action taken:
Interface Card parameters for a specific card or ATM
Interface Module parameters for a specific slot “slot
ID” or for all slots (for slot ID=0) are displayed.
System message display:
Information is displayed as shown in the examples.