Filter
Top Products
286
C
HAPTER
9: M
ANAGING
LAN E
MULATION
Update ELAN
Parameters in LES
Database
Update the parameters for the specified ELAN in the LES database.
Table 40 describes the ELAN parameters you can update.
CAUTION:
After you use this command to update the parameters of an
ELAN in the LES database, you must use the LMA to update the
parameters of the ELAN in the LECS database in exactly the same way.
(For more information, see “Update ELAN Parameters in LECS Database”
on page 251.)
After updating the parameters, the ELAN is reset, that is, the control
distribute channel to all LECs that are attached to the ELAN is
disconnected.
Command Actions
Command Result
Enter menu sequence:
(2) LEM: LAN Emulation
(2) LES: LE Services
(4) EFP: LES Edit ELANs Parameters
Enter a parameter at the prompt
Parameter Format or Range
ELAN ID
1
–
16
For more information, see “Display ELAN Parameters in
LES Database” on page 283.
ELAN type
1
-Ethernet
2
-Token ring
3
-VLT
Elan max frame size
1
-1516
2
-4544
Direct access sequence:
2 2 4
[parameters]
System action taken:
The parameters for the specified ELAN are updated.
The update takes place immediately.
System message display:
ELAN is reset.