Filter
Top Products
Signaling Setup
169
Update VPI/VCI
Range
Update the VPI/VCI configuration parameters of the specified port. You
set maximum and minimum VPI/VCI values for each port. For more
information, see “Display VPI/VCI Range” on page 167.
Note that when the ILMI auto-configuration procedure is enabled, the
VPI/VCI limits are determined automatically and override any settings
made by this command. (For more information, see “Display Current IP
Configuration” on page 56.)
Command Actions
Command Result
Enter the menu sequence:
(1) SYS: Platform configuration
(1) SET: Switch setup
(4) SIG: Signaling setup
(3) VCC: VPI/VCI range setup
(2) SET: Set VPI/VCI range
Enter a parameter at the prompt
Parameter Format or Range
Port number <slot.group.port> or
0.0
for all
Parameter number
1
for Min VPI
2
for Max VPI
3
for Min VCI
4
for Max VCI
Parameter value The VPI/VCI value.
Direct access sequence:
1 1 4 3 2
[parameters]
Only one parameter can be defined per command.
System action taken:
The selected VPI/VCI configuration parameters are
updated for the specified port.
System message display:
Parameter was successfully set.