Filter
Top Products
144
C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Call Parameters
Table 20 shows the call parameters displayed by the command.
Table 20 Call Parameters
Name Description
Call number This is the unique number that identifies the call.
Call Type Whether the call is SVC or PVC, and if it is a point-to-point
or point-to-multipoint call.
When showing a connection of LAN Emulation,
point-to-point indicates use of the control direct VCC (for
LES), or the multicast sent VCC (for BUS).
When showing a connection of point-to-multipoint, it
indicates use of the control distribute VCC (for LES) or
Multicast forward VCC (for BUS).
Call State Whether the call is active or not.
Number of Out
Connections
The number of output destinations that the call is routed
to. In a point-to-point call, this is always one; whereas in a
point-to-multipoint call, this number may be greater than
one.
Priority Whether the call cells are transferred through the Switch
using the high priority queue or low priority queue.
CLL (Cell Loss Level) The queue saturation level at which cells with their CLP bit
set are discarded. The possible values can be: “no discard
at all”,” 20%”, “50%”, “80%”.
In Connection VPI The Virtual Path Identifier (VPI) number of the input port.
In Connection VCI The Virtual Channel Identifier (VCI) number of the input
port.
In Connection Port The port number of the input port.
In Connection ATM
Address Member
The ATM address member of the source. (If the source is
not SVC, this field does not appear.)
Out Connection VPI The Virtual Path Identifier (VPI) number of the output port.
Out Connection VCI The Virtual Channel Identifier (VCI) number of the output
port.
Out Connection Port The port number of the output port.
Out Connection ATM
Address Member
The ATM address member of the destination. (If the
source is not SVC, this field does not appear).