Filter
Top Products
Setting Interface Parameters
391
Reset PNNI Interface
Parameters to Default
Values
Resets all the PNNI interface parameters for the specified interface port
(as selected in the Select Port option) to their default values. The
parameter reset takes place immediately. See “Select Port for Interface
Parameter Setting” on page 383 for details.
Command Actions
Command Result
Example
Enter:
1 1 9 4 4 2 7 y
The following message is displayed:
Interface parameters were set to their defaults
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(8) SDF: Set to Defaults
Enter a parameter at the prompt
Parameter
Format or Range
Confirm reset
y
or
n
Direct access sequence:
1 1 9 4 4 2 8
System action taken:
The interface parameters for the specified port are set
to their default values.
System message display:
Interface parameters were set to their
defaults.