Filter
Top Products
196
C
HAPTER
8: V
IEWING
S
TATISTICS
Display Counters Per
VPI/VCI
Display total cells through a connection specified by its VPI/VCI, presented
according to the setting of the CLP bit. If the call is P2M (Point to
Multipoint), the transmit or receive information is not always applicable.
Command Actions
Command Result
Example
Enter:
4 2 3 1.1.1
3 200
The following message is displayed:
Enter the menu sequence:
(4) STS: Statistics
(2) ATM: ATM layer
(3) GVP: Get counters per vpi/vci
Enter a parameter at the prompt
Parameter Format or Range
Port ID <slot.group.port>
VPI Perform menu item
(3)CON\(2)RTG\(1)CLL
to get
the VPI/VCI values for a call. See “Display Call Routed
to ATM Address” on page 140 for details.
VCI
Direct access sequence:
4 2 3
[parameters]
System action taken:
The total number of cells through a connection is
displayed according to the setting of the CLP bit.
System message display:
Information is displayed as shown in the example.
ATM Statistics per VPI/VCI:
---------------------------
Ingress cells with clp0 set: 2
Ingress cells with clp1 set: 1
Egress cells with clp0 set: 2
Egress cells with clp1 set: 3