Filter
Top Products
94
C
HAPTER
5: C
ONFIGURING
THE
P
LATFORM
Interface Module slot occupancy information for the 7-slot chassis is
displayed as follows:
Interface Card Parameters
Table 15 describes the interface parameters displayed by the command
for a specific slot ID.
Slot id Slot status Interface card type Interface card status
------- ------------ ------------------- ---------------------
1 Occupied ATM I/F card Up
2 Free Doesn’t exist
3 Free Doesn’t exist
4 Free Doesn’t exist
5 Occupied ATM I/F card Up
6 Free Doesn’t exist
7 Free Doesn’t exist
Table 15 Interface Parameters
Parameter Description
Port ID The port number for each of the module’s ports in the
format slot.group.port.
Interface Type The port interface type (for example, OC3-SC). The type
determines the interface, including the type of connector.
Media Type The type of media used by the port (for example, coaxial
cable, multi-mode fiber).
Operational Status The port may be “up” or “down”, “up & connect” , or
“doesn’t exist.”
Port Status Whether the port has been enabled or disabled by
management. Can be either “enabled” or “disabled”. If a
port is disabled, the CoreBuilder
®
9000 cannot connect to
the other side via this port.
Frame Mode The interface framing mode. Can be SDH or SONET.
Clock Src This may be normal (Nrm) or Loop timing (Lpt).
Loop Mode Indicate the loopback state of the ATM interface module
port. May be “None”, “Loop Forward” or “Loop Back”.