Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-50Add IP Interface Assembly
6
Connect the Ethernet
1. Connect the network cable to the ETHERNET connector on the TN802B
external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B and TN802B circuit packs are hot-swappable, so you do not
need to power down the carrier to install them.
If you need to remove the TN802B IP Interface from the carrier at a later
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see Figure 6-22
) of the TN802B IP Interface until the LCD
shows a flashing
MSHUT *
. When the flashing stops and the asterisk
disappears (about 2 min), it is safe to remove the circuit pack.
Table 6-5. U.S. Robotics Modem Dip Switch Settings
Dip
Switch Setting Description
1
UP
DOWN
Data Terminal Ready normal
Data Terminal Ready override
2
UP
DOWN
Verbal result codes
Numeric result codes
3
UP
DOWN
Suppress result codes
Display result codes
4
UP
DOWN
Echo offline commands
No echo, offline commands
5
UP
DOWN
Auto answer on first ring or higher if specified in NVRAM
Auto answer off
6
UP
DOWN
Carrier detect normal
Carrier detect override
7
UP
DOWN
Load NVRAM defaults
Load factory defaults
8
UP
DOWN
Dumb mode
Smart mode