Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Upgrading G3rV2, V3, V4 to R8r and Adding Memory
1-15Upgrade the software and hardware
1
Verify Interchange (H/C only)
This step is performed twice, once for each carrier but not at the same time.
NOTE:
Because of the memory mismatch between the standby and active SPEs,
typing the
status spe
command yields two different scenarios.
After the circuit packs have been replaced in the first carrier:
1. Type
status spe
and press
Enter:
■ The
Standby Refreshed
field shows
no
■ The
Standby Shadowing
field shows
off
■ The
Standby Handshake
field shows
up
2. Go to Upgrade other carrier (H/C only)
After the circuit packs have been replaced in the second carrier:
1. Type
status spe
and press
Enter to make sure the active side is ready for
interchange. When it is ready,
■ The
Standby Refreshed
field shows
yes
■ The
Standby Shadowing
field shows
on
■ The
Standby Handshake
field shows
up
2. Go to Affix position label(s)
Upgrade other carrier (H/C only)
To upgrade the other carrier, lock the SPE switches on the DUPINT to the other
carrier.
NOTE:
The new active carrier resets (cold 2 restart). Wait until the login prompt
appears then log in.
Repeat the steps from Check the active tone-clock (H/C only)
through Verify
Interchange (H/C only).
Affix position label(s)
1. Place the new strip label(s) over the old carrier label(s).