Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-51Add IP Interface Assembly
6
Figure 6-22. TN802B IP Interface faceplate
NOTE:
If replacing the existing TN799 circuit pack, remove it first and replace it
with the new one.
1. Insert the TN799B circuit pack into the port slot identified earlier.
NOTE:
To properly seat the circuit pack, push firmly on the front of the
faceplate until the latch reaches the bottom rail of the carrier. Then
close the latch until it is fully engaged.
Figure Notes
1. LCD display
2. Reset button (recessed)
3. Red board status LED
4. PCMCIA card slot
5. Yellow PCMCIA disk-in-use LED
1
2
3
4
5
fpdfmapd KLC 030899