Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-74Add IP Interface Assembly
6
Connect the Monitor, Keyboard, and Mouse
1. Attach a VGA monitor to the VGA connector of the TN802 IP Interface
external cable assembly.
2. Attach the keyboard to the KEYBOARD connector of the external cable
assembly.
3. Attach the mouse to the MOUSE connector of the external cable
assembly.
4. Plug the monitor into an AC power receptacle and turn it on.
5. If upgrading locally, reboot Windows NT by pressing the recessed reset
button on the faceplate (see Figure 6-26
) of the TN802B IP Interface until
the LCD shows a flashing
MSHUT *
. When the flashing stops and the
asterisk disappears (about 2 min), it is safe to remove the circuit pack.
6. After the TN802B is shut down, reseat the circuit pack to restart the
system.
7. Log in using
ctrl alt del
Upgrading IP trunks (R7) to H.323 trunks
If there are existing IP trunk connections that you want to upgrade to H.323 trunk
connections, do the following steps. Otherwise, go to
‘‘Upgrade to TN802B (R8)’’
on page 6-76
To upgrade an existing IP trunk (R7) to an H.323 trunk (R8) requires first getting
IP information from the existing TN802 before upgrading the TN802 to TN802B.
1. Click on
My Computer > Control Panel > Network
.
2. Click the
Protocols
tab.
3. Select
TCP/IP Protocol
from the list.
4. Click the
Properties
option in the Network window. Write down the IP
address, subnet address, and gateway address shown for adaptor [2]
(see example below).
NOTE:
Do not use the addresses for adapter [1].