Filter
Top Products
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Upgrading G3rV2, V3, V4 to R8r and Adding Memory
1-9Upgrade the software and hardware
1
Install Disk Drive (if not TN1657 V4 or earlier)
!
CAUTION:
When replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
!
CAUTION:
If a high or critical reliability system, replace and restore the disk drives one
at a time starting with the standby SPE. Never replace the active and
standby disk drives at the same time.
1. Type
busyout host-adapter
[
a
|
b
]
and press Enter to prevent other
applications from accessing the disk or removable media.
2. Remove the existing TN1657 Disk Drive circuit pack and place it in
antistatic material.
3. Insert a new TN1657 circuit pack into the DISK DRIVE slot.
4. To properly seat the circuit pack, push firmly on the front of the faceplate
until the latch reaches the bottom rail of the carrier. Then close the latch
until it is fully engaged.
5. Type
release host-adapter
[
a
|
b
] and press
Enter to release the disk from
the maintenance-busyout condition and put it back into service.
6. Type
reset host-adapter
[
a
|
b
]
and press
Enter to allow the disk to spin
up.
7. Type
status spe
and press
Enter to verify that the disk is now in service.
NOTE:
If the disk fails to return to service, repeat Steps 1, 3, 4, and 5.
For high or critical reliability, repeat steps 1 through 7 on the active carrier.
Restore Disk
NOTE:
Until this command finishes, the system provides no user feedback on the
management terminal screen. Do not press
Enter while the command
executes. Doing so causes the terminal screen to clear as the command
finishes; erasing any success or failure messages the system may provide.
If standard reliability:
1. Type
restore disk full
and press
Enter to copy the information on the
removable media to disk, which takes about 30 minutes.
If high or critical reliability:
1. Type
restore disk full both
and press
Enter.