Filter
Top Products
Chapter 22: Linking and Upgrading 369
22LINK.DOC TI-89/TI-92 Plus: Linking and Upgrading (English) Susan Gullord Revised: 02/23/01 1:23 PM Printed: 02/23/01 2:20 PM Page 369 of 18
Shown on: Message and Description:
Sending
unit
This is displayed after several seconds if:
¦ A cable is not attached to the sending unit’s I/O port.
— or —
¦
A receiving unit is not attached to the other end of the
cable.
— or —
¦ The receiving unit is not set up to receive.
Press
N
or
¸
to cancel the transmission.
Sending
unit
The receiving unit does not have the correct certification
for the product software (base code) or Flash application
being sent.
Receiving
unit
The receiving unit has a variable with the same name as
the specified variable being sent.
¦ To overwrite the existing variable, press
¸
. (By
default,
Overwrite = YES
.)
¦ To store the variable to a different name, set
Overwrite
= NO
. In the
New Name
input box, type a variable
name that does not exist in the receiving unit. Then
press
¸
twice.
¦ To skip this variable and continue with the next one,
set
Overwrite = SKIP
and press
¸
.
¦ To cancel the transmission, press
N
.
Receiving
unit
The receiving unit does not have enough memory for what is
being sent. Press
N
or
¸
to cancel the transmission.
Common Error and
Notification
Messages
Note: The sending unit may
not always display this
message. Instead, it may
remain BUSY until you
cancel the transmission.
New Name is active
only if you change
Overwrite to NO.