Filter
Top Products
• If your system uses an external controller and the HP E1406
Command Module, put the digitizer in the servant area of the
Command Module. This enables the module to function as the
HP-IB interface to the digitizer.
The HP E1406 Command Module has a factory set logical address of
0 and a servant area switch setting of 255. Using the factory settings,
it is not necessary to change the logical address of the digitizer (40)
to place it in the servant area of the Command Module.
• If the digitizer is used with the HP E1485 Digital Signal Processing
(DSP) module, the digitizer must be in the servant area of the DSP
module.
The digitizer’s logical address switch is shown in Figure 1-2.
Figure 1-2. HP E1429A/B Logical Address Switch Location
Chapter 1 Gettin
g
Started 17