Programming
Sequence
The recommended sequence for programming the digitizer is shown in
Figure 1-5. Note that CONFigure sets many digitizer parameter values that
usually do not have to be changed with "lower-level" subsystem commands.
The lower-level commands are used when you want to set a value different
from the value set by CONFigure.
CONFigure
command
INPut
subsystem
commands
SENSe
subsystem
commands
ARM and TRIGger
subsystem
commands
OUTPut
subsystem
commands
VINStrument
subsystem
commands
FORMat
subsystem
commands
INITiate and
FETCh or READ
subsystems
MEASure
command
Figure 1-5. HP E1429A Programming Sequence
36 Getting Started Chapter 1