Filter
Top Products
which is in GENerate mode. The mode is not active until either an INITiate
command or a VINStrument:CONFigure:LBUS:MEMory:INITiate command is
sent.
OFF: The Local bus interface is disabled immediately upon receipt of this
command. Local bus data is neither used nor passed through.
PIPeline: Local bus data is passed through and not altered. This mode becomes
effective immediately upon receipt of this command. Select this mode when
data should be transparently passed through the HP E1429B. The module will
remain in the PIPeline mode even after an end of frame flag is received;
therefore, it is necessary to change modes to take the module out of PIPeline
mode.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
mode
discrete APPend|GENerate|
INSert|OFF|
PIPeline
none
Comments • Executable when initiated: No
• Coupled command: Yes
• Related Commands: ARM subsystem, TRIGger subsystem,
VINStrument:CONFigure:LBUS:FEED,
VINStrument:CONFigure:LBUS:MEMory:INITiate, INITiate,
VINStrument:CONFigure:VME:MODE
• *RST Condition: VINStrument:CONFigure:LBUS:MODE OFF
Example Setting the Local Bus operation mode
VINS:LBUS PIP Set pipeline (pass through) mode; this
becomes active immediately
[:CONFigure]:LBUS:RESet
VINStrument[:CONFigure]:LBUS:RESet will reset the digitizer’s Local bus
chip. This command should be used when it is necessary to put the Local bus chip
into a known state without altering any other digitizer settings
(TRIGger:STARt:COUNt, TRIGger:STARt:SOURce, etc.). The *RST command
also resets the Local bus chip, but *RST forces all instrument settings to initial
values.
VINStrument[:CONFigure]:LBUS:RESet
288 Command Reference VINStrument Subsystem