Filter
Top Products
Subsystem Commands Description
DIAGnostic
(cont’d)
DIAGnostic:FETCh[<chan >]? <
start_addr
>, <
count
>
DIAGnostic:MEMory[<
chan
>]:FILL <
num_segments
> ,
<
count
>
DIAGnostic:MEMory[<
chan
>]:ADDResses?
DIAGnostic:PEEK? <
address
>, <
bits
>
DIAGnostic:POKE <
address
>, <
bits
>, <
value
>
DIAGnostic:SGET? <
bit
>
DIAGnostic:SPUT? <
bit
>, <
value
>
DIAGnostic:TEST?
Returns count number of readings
beginning at start_addr.
Fill num_segments in memory with count
readings.
Returns the addresses of the next memory
locations to be written to in each segment.
Read the specified number of bits from the
memory location specified.
Write the value to the address specified.
Returns the state (0 or 1) of the specified
bit in the serial control register.
Sets the state (0 or 1) of the specified bit in
the serial control register.
Returns information on a failed self-test.
FETCh FETCh[<
chan
>]?
FETCh[<
chan
>]:COUNt?
FETCh[<
chan
>]:RECover?
Returns readings from the specified
channel.
Returns the number of readings stored in
memory from the channel specified.
Returns readings from the specified
channel following a power-failure, digitizer
configuration change, or reset.
FORMat FORMat[:DATA] <
type
>[,<
length
>] Specifies the output format for the
measurement data.
INITiate INITiate[:IMMediate] Initiates the digitizer trigger system and
places the digitizer in the wait-for-arm or
wait-for-trigger state.
INPut INPut[<
port
>]:FILTer[:LPASs][:STATe] <
mode
>
IINPut[<
port
>]:IMPedance <
impedance
>
INPut[<
port
>][:STATe] <
mode
>
Enables/disables the 10 MHz input filter.
Sets the single ended port input impedance.
Connects/disconnects the input ports from
the signal path.
MEASure MEASure[<
chan
>]:ARRay[:VOLTage][:DC]? (<
size
>)
[,<
expected value
>[,<
resolution
>]]
[,(@<
input por t
>)]
Configures the digitizer and takes <size>
number of readings on the specified
channel and input port.
MEMory MEMory:BATTery:CHARge?
MEMory:BATTery[:STATe] <
state
>
Checks the charge on the battery
supporting non-volatile memory.
Enables/disables the battery supporting
non-volatile memory.
Table 4-1. HP E1429A/B Command Quick Reference (Cont’d).
Chapter 4 Command Quick Reference 311