Filter
Top Products
[:CONFigure]:LBUS:FEED
VINStrument[:CONFigure]:LBUS:FEED <source > indicates the source of the
data which will be output to the Local bus. The data source may be channel 1,
channel 2, or both channels. The data may come from memory or directly from the
A/D converter(s). Sources beginning with "MEMory: " are the post measurement
modes, sources beginning with "CONVerter: " are the real time modes. The possible
sources are:
" MEMory:CHANnel1" : Channel 1 memory is the data source for the Local bus.
Two bytes per reading will be output to the bus.
" MEMory:CHANnel2" : Channel 2 memory is the data source for the Local bus.
Two bytes per reading will be output to the bus.
" MEMory:BOTH" : Both channels of memory are the data source for the Local
bus. In this mode, the channel 2 reading is output first, followed by the
channel 1 reading. Four bytes for each set of readings will be output to the bus.
" CONVerter:CHANnel1" : The channel 1 A/D converter is the data source for
the Local bus. Two bytes per reading will be output to the bus.
" CONVerter:CHANnel2" : The channel 2 A/D converter is the data source for
the Local bus. Two bytes per reading will be output to the bus.
" CONVerter:BOTH" : Both A/D converters are the data source for the Local bus.
In this mode, the channel 2 reading is output first, followed by the
channel 1reading. Four bytes for each set of readings will be output to the bus.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
source
string "CONVerter:BOTH" |
"CONVerter:CHANnel1" |
"CONVerter:CHANnel2" |
"MEMory:BOTH" |
"MEMory:CHANnel1" |
"MEMory:CHANnel2" |
none
Comments • Executable when initiated: No
• Coupled command: Yes, this command is set but ignored if
VINStrument:CONFigure:LBUS:MODE is not GENerate, APPend, or INSert.
VINStrument [:CONFigure]:LBUS:FEED
VINStrument Subsystem Command Reference 285