Filter
Top Products
Subsystem Commands Description
OUTPut OUTPut:ECLTrg<
n
>:FEED <
source
>
OUTPut:ECLTrg<
n
>[:STATe] <
mode
>
OUTPut:EXTernal[1]:FEED <
source
>
OUTPut:EXTernal[1][:STATe] <mode>
OUTPut:TTLTrg<
n
>:FEED <
source
>
OUTPut:TTLTrg<
n
>[:STATe] <
mode
>
Specifies the source of the synchronization
pulse routed to ECLTRG0 or ECLTRG1.
Enables/disables the routing of the
synchronization pulse.
Specifies the source of the synchronization
pulse routed to the "Ext 1" BNC port.
Enables/disables the routing of the
synchronization pulse.
Specifies the source of the synchronization
pulse routed to a TTLTRG trigger line.
Enables/disables the routing of the
synchronization pulse.
READ READ[<
chan
>]?
Returns readings from the specified
channel.
SENSe [SENSe[<
chan
>]]:FUNCtion <
function
>
[SENSe[<
chan
>]]:ROSCillator:EXTernal:FREQuency
<
frequency
>
[SENSe[<
chan
>]]:ROSCillator:SOURce <
source
>
[SENSe[<
chan
>]]:SWEep:OFFSet:POINts <
count
>
[SENSe[<
chan
>]]:SWEep:POINts <
count
>
[SENSe[<
chan
>]]:VOLTage[:DC]:RANGe <
range
>
[SENSe[<
chan
>]]:VOLTage[:DC]:RESolution?
Selects the channel’s input port that will be
used.
Indicates the frequency of the external
reference source.
Selects the reference frequency source.
Specifies the number of pre-arm readings.
Specifies the total number of (pre- and
post-arm) readings taken during each arm
cycle.
Sets the digitizer measurement range.
Queries the digitizer reading resolution.
STATus STATus:OPC:INITiate <
state
>
STATus:OPERation|:QUEStionable:CONDition?
STATus:OPERation|:QUEStionable:ENABle <
unmask
>
STATus:OPERation|:QUEStionable[:EVENt]?
STATus:OPERation|:QUEStionable:NTRansition
<
unmask
>
STATus:OPERation|:QUEStionable:PTRansition
<
unmask
>
STATus:PRESet
Controls whether *OPC, *OPC?, and *WAI
will complete immediately, or wait for the
measurement or data transfer to complete.
Reads the settings of the condition register.
Specifies which bits in the event register
are included in the summary bit.
Reads the settings of the event register.
Sets the negative transition mask.
Sets the positive transition mask.
Initializes the enable registers and
transition masks, and sets
STATus:OPC:INITiate ON.
SYSTem SYSTem:ERRor?
SYSTem:VERsion?
Reads the error codes and messages in
the digitizer error queue.
Returns the SCPI conversion to which the
digitizer complies.
Table 4-1. HP E1429A/B Command Quick Reference (Cont’d).
312 Command Quick Reference Chapter 4