• *RST Condition: all saved states set to the same state as the *RST state
*RMC
*RMC <name> purges only the specified macro definition.
NOTE: At printing time, *RMC is a command proposed and accepted for a revision
and re-designation of IEEE-488.2.
Comments • Use the *PMC command to purge all macro definitions in one command.
• Executable when initiated: Yes
• Coupled command: No
• Related commands: *DMC, *PMC
• *RST Condition: none
*RST
*RST resets the HP E1429 as follows:
• Sets all commands to their *RST state.
• Aborts all pending operations including VME bus or Local bus transfers.
• Loads calibration constants from non-volatile calibration memory.
*RST does not affect:
• The state of VXIbus word serial protocol
• The output queue
• The Service Request Enable Register
• The Standard Event Status Enable Register
• The enable masks for the OPERation Status and Questionable Signal registers
• Calibration security state
• Protected user data
• The memory backup battery
Comments • Executable when initiated: Yes
• Coupled command: No
• *RST Condition: none
*RMC
Chapter 4 Command Reference 306