Filter
Top Products
*SAV
*SAV <number> stores the current programming state into one of the 10 possible
stored state areas. Number indicates which of the stored state areas should be used.
This command stores the states of all commands affected by *RST. Exceptions
include MEMory:BATTery:STATe, the STATus subsystem commands, and the
CALibration:SECurity command state.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
number
numeric 0 through 9 none
Comments • Executable when initiated: Yes
• Coupled command: No
• Related Commands: *LRN?, *RCL, *RST
• *RST Condition: unaffected
• Power-on Condition: all saved states set to the same state as the *RST state
*SRE and *SRE?
*SRE <mask> specifies which bits of the Status Byte Register are enabled to
generate a service request (VXIbus reqt signal). Event and summary bits are always
set and cleared in the Status Byte Register regardless of the enable mask. Mask is
the sum of the decimal weights of the bits to be enabled.
The query form returns the current enable mask.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
mask
numeric 0 through 255 none
A 1 in a bit position enables service request generation when the corresponding
Status Byte Register bit is set; a 0 disables it.
Comments • Executable when initiated: Yes
• Coupled command: No
*SAV
307 Command Reference Chapter 4