Filter
Top Products
*CLS
*CLS clears the Standard Event Status Register, the Operation Status Register, the
Questionable Signal Register, and the error queue. This clears the corresponding
summary bits (3, 5, & 7) in the Status Byte Register. *CLS does not affect the
enable masks of any of the status registers.
Comments • Executable when initiated: Yes
• Coupled command: No
• Related Commands: STATus:PRESet
• *RST Condition: none
*DMC
*DMC <name>,<data> creates a macro with the specified name and assigns zero,
one, or a sequence of commands to the name. The sequence may be composed of
SCPI and/or Common Commands.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
name
string
data
1 through 12 characters none
data
block
data
or
string
any valid command
sequence
none
Comments • Legal macro names must start with an alphabetic character and contain only
alphabetic, numeric, and underscore ("_") characters. Alphabetic character case
(upper vs. lower) is ignored.
The name is allowed to be the same as a SCPI command, but may be not be the
same as a Common Command. When the name is the same as a SCPI command,
the macro rather than the command will be executed when the name is received if
macro usage is enabled. The SCPI command will be executed if macro usage is
disabled.
• The <data > in the *DMC command is parsed by the digitizer when the *DMC
command is executed.
• Executable when initiated: Yes
*CLS
299 Command Reference Chapter 4