Filter
Top Products
• The CONFigure command configures the HP E1429 to do the measurement
specified by the parameters given with CONFigure. All instrument settings will
be forced to their *RST values, with the following exceptions. In particular, note
that all OUTPut signals are turned off and their FEED’s are changed to reset
values, and that both the local bus (VINStrument:LBUS) and VME bus
(VINS:VME) are turned off. Be aware that these new states will still be in effect
after the CONFigure command is complete. See Appendix B, Table B-2 for a
complete list of the reset settings for the HP E1429. The following states are set
up after the reset, and thus in most cases, will not be the *RST value for that
command:
a. SENSe<n>:FUNCtion is set to "VOLTage[:DC] <port>"
b. SENSe<n>:VOLTage:DC:RANGe is set to the value implied by the
expected value given.
c. INPut[<port>]:FILTer is set to ON.
d. SENSe:SWEep:POINts and TRIGger:STARt:COUNt are set to the <size>
parameter.
• Related commands: SENSe:FUNCtion, SENSe:VOLTage:RANGe,
SENSe:SWEep:POINts, SENSe:ROSCillator:SOURce, TRIGger:STARt
subsystem, ARM:STARt subsystem.
• *RST Condition: none
Example Measuring 1.5 V on the differential input of channel 1
CONF:ARRay:VOLT (20),1.5,(@3) Set up to take 20 readings of 1.5 Volts peak
on port 3 of channel 1.
INIT Start the measurement
FETC? Get channel 1 readings
CONFigure[<
chan
>]:ARRay:[VOLTage][:DC]
CONFigure[<
chan
>] Subsystem Command Reference 215