Filter
Top Products
*LRN?
*LRN? returns a sequence of commands that may be re-sent to the HP E1429 to
return it to its current programming state.
Only those commands that are affected by *RST are included in the sequence.
Exceptions include MEMory:BATTery:STATe, the STATus subsystem commands,
and the CALibration:SECurity command state.
Note *LRN? should be sent singly in a program message, since the number of commands
in the returned sequence is large, and may vary depending on firmware revision.
Comments • Executable when initiated: Yes
• Coupled command: No
• Related commands: *RCL, *RST, *SAV
• *RST Condition: none
*OPC
*OPC causes the HP E1429 to wait for all pending operations to complete. The
Operation Complete bit (bit 0) in the Standard Event Status Register is then set.
If STATus:OPC:INITiate OFF is set, the Operation Complete bit will be set when
all commands received prior to the *OPC have been executed. If ON is set, *OPC
waits for the digitizer to return to the idle state before setting the Operation
Complete bit. No other commands will be executed until the Operation Complete
bit is set.
Comments • Executable when initiated: Yes
• Coupled command: No
• Related commands: *OPC?, *WAI
• *RST Condition: none
*LRN?
303 Command Reference Chapter 4