Filter
Top Products
R
Rate, arm, 118
Re-initiating the digitizer, 378
READ? subsystem, retrieving readings, 139
Reading and writing to the shift register, 369
Reading resolution, 136
Reading the data register, 153
Readings, locating in memory, 142
Readings, transfer rates, 137
Recalling digitizer configurations
*RCL, 175
Reference clock, 124
Reference source
setting, 124
Register descriptions
arm count, 374
arm delay, 360
arm source, 373
Register interface, 105
Register programming
aborting measurements, 377
setting the arm count, 374
setting the arm delay, 374
setting the arm source, 373
Register-based programming
example program system configuration, 341
Registers
arm count, 374
arm delay, 360
arm source, 373
Removing the arbitrary block header, 135
Reset configuration, 25
Resetting and clearing the digitizer, 23
Resolution, reading, 136
Retrieving readings using
DIAGnostic:UPLoad:SADDress?, 141
Retrieving readings using READ?, 139
Retrieving readings with the FETCh? subsystem, 139
Retrieving readings, determining the number of, 140
Retrieving readings, methods, 137
Retrieving readings, transfer speeds, 137
Routing the signal to a source, 120, 128
S
Safety warnings, 10
Sample period
description, 122
setting, 122
Sampling
dual rate, 123
Saving digitizer configurations, 174
*SAV, 175
SCPI
Conformance Information, 314
SCPI command control
input section, 106
SCPI command coupling, 182
SCPI command execution, 182
SCPI command listings
as found in the manual, 28
SCPI command parameters, 180
SCPI Commands, 177
Format, 179
Reference, 184
SCPI Conformance Information, 314
SCPI programming, 28
SCPI programming, introduction, 33
Segmented memory, 131
Segmented Reading transfers, 153
Segmented readings, where they are stored, 143
Selecting the input port, 107
Self-test, digitizer, 21
Sending an immediate trigger, 125
Sending commands to the digitizer, 105
Sending the *IDN? command, 20
SENSe, and TRIGger subsystems overview, 121
Separating pre- and post-arm readings, 140
Separator
Command, 179
Setting the arm count, 117
Setting the arm count, procedure, 374
Setting the arm delay, 117
Setting the arm delay, procedure, 375
Setting the arm level, 116
Setting the arm signal slope, 115
Setting the arm source, 114
Setting the arm source, procedure, 373
Setting the input impedance, 108
Setting the input impedance, register-based, 370
Setting the interleaved transfer mode, 406
Setting the Local bus data source, 163
Setting the Local bus transfer mode, 162
Setting the measurement range, register-based, 370
Setting the pre-arm reading count, 125
Setting the reference source, 124
Setting the signal range, 109
Setting the trigger count, 125
Setting the trigger source, 121
Setting the VME bus data source, 152
Setting the VME bus transfer mode, 151
Settings, querying, 43
Shift register, reading and writing, 369
Shift register, using, 368
HP E1429A/B User’s Manual Index - 419