Filter
Top Products
Subsystem Commands Description
TRIGger
ABORt
TRIGger[:STARt]:COUNt <
number
>
TRIGger[:STARt][:IMMediate]
TRIGger[:STARt]:SOURce <
source
>
TRIGger[:STARt]:TIMer1 <
period
>
TRIGger[:STARt]:TIMer2 <
period
>
Removes the digitizer from the
wait-for-trigger state.
Specifies the total number of (pre- and
post-arm) readings taken during each arm
cycle.
Sends an immediate trigger to the digitizer.
A reading is taken if the digitizer is in the
wait-for-trigger state.
Sets the trigger source.
Sets the digitizer sample rate.
Sets the post-arm sample rate for dual rate
sampling.
VINStrument
VINStrument[:CONFigure]:LBUS:FEED <source>
VINStrument[:CONFigure]:LBUS:MEMory:INITiate
VINStrument[:CONFigure]:LBUS[:MODE] <mode>
VINStrument[:CONFigure]:LBUS:RESet
VINStrument[:CONFigure]:LBUS:SEND:POINts
<count>
VINStrument[:CONFigure]:LBUS:SEND:POINts:AUTO
<mode >
VINStrument[:CONFigure]:TEST:DATA <voltage_list>
VINStrument[:CONFigure]:VME:FEED <source>
VINStrument[:CONFigure]:VME:MEMory:INITiate
VINStrument[:CONFigure]:VME[:MODE] <mode>
VINStrument[:CONFigure]:VME:SEND:ADDRess:DATA?
VINStrument:IDENtity?
Sets the Local bus data source.
Places the digitizer in the wait-for-trigger
state and starts the data transfer from
digitizer memory to the Local bus.
Sets the Local bus operating mode.
Resets the digitizer’s (E1429B) Local bus
chip.
Sets the number of readings per Local bus
transfer block.
Sets the digitizers to the Local bus
interleaved transfer mode.
Tests the Local bus by transmitting a list of
data.
Sets the VME (VXI data transfer) bus data
source.
Places the digitizer in the wait-for-trigger
state and starts the data transfer from
digitizer memory to the VME (VXI data
transfer) bus.
Sets the VME (VXI data transfer) bus mode.
Returns the A24 offset address used to
read measurement data from memory.
Indicates the virtual instrument capability of
the digitizer.
Table 4-1. HP E1429A/B Command Quick Reference (Cont’d).
Chapter 4 Command Quick Reference 313