Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-70
v1.0, November 2010
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is “auto” or “mac-based”. If the control mode is not
“auto” or “mac-based”, an error will be returned.
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the
dot1x configuration is retained and can be changed, but is not activated.
Format no dot1x port-control all
Mode Global Config
Format dot1x re-authenticate <unit/slot/port>
Mode Privileged EXEC
Default disabled
Format dot1x re-authentication
Mode Interface Config
Format no dot1x re-authentication
Mode Interface Config