Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Log Messages 8-22
v1.0, November 2010
Table 8-48: PIM-SM Log Messages
Component Message Cause
PIM-SM PIM-SM not initialized This message arises when trying to activate
pimsm interfaces or receiving pimsm
packets when pimsm component is not
initialized.
PIM-SM Unable to take xxx semaphore This message is logged when failed to
acquire semaphore to access source list or
group list or candidate Rp list or virtual
interface list. The xxx specifies the list for
which the access is denied.
PIM-SM Warning : Could not send packet type xxx
(pimsm packet type) on rtrIfNum
this warning is logged when failed to send a
pimsm control packet on the specified router
interface.
PIM-SM add_kernel_cache : memory allocation
failed
This message is logged when there is
insufficient memory to add an mroute entry
into cache.
PIM_SM Config error. Trying to add static RP.
Dynamic RP with same ip addr exists
Router learns RP-group mapping through
Bootstrap messages received.This message
pops when the static RP is configured which
conflicts the mapping learnt dynamically
through Bootstrap messages.
PIM-SM Inner xxx(source/group) address of register
message is invalid
This log message appears when a register
message is received with invalid inner ip
source or group address.
Table 8-49: PIM-DM Log Messages
Component Message Cause
PIM-DM Out of memory when creating xxx This message is logged when there is
insufficient memory to accommodate a new
neighbor/(S,G) Entry, Prune, Graft, Join etc.
PIM-DM Error entry->ll_xxx LL creation error This message is logged when the SLL
creation is Failed.
PIM-DM pim_interface_set: Could not give taskSema This message is logged when Task
synchronization Semaphore release fails.
PIM-DM Error initializing CACHE This message is logged when the PIM-DM
(S,G) entry Cache table initialization fails.