Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-11
v1.0, November 2010
Spanning Tree Protocol (STP) Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP). STP
helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the spanning-
tree configuration is retained and can be changed, but is not activated.
spanning-tree bpdufilter default
Use this command to enable BPDU Filter on all the edge port interfaces.
no spanning-tree bpdufilter default
Use this command to disable BPDU Filter on all the edge port interfaces.
Default enabled
Format spanning-tree
Mode Global Config
Format no spanning-tree
Mode Global Config
Default disabled
Format spanning-tree bpdufilter
Mode Global Config