Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-12
v1.0, November 2010
class-map
This command defines a DiffServ class of type match-all. When used without any match
condition, this command enters the class-map mode. The <class-map-name> is a case
sensitive alphanumeric string from 1 to 31 characters uniquely identifying an existing DiffServ
class.
The class type of match-all indicates all of the individual match conditions must be true for a
packet to be considered a member of the class.This command may be used without specifying a
class type to enter the Class-Map Config mode for an existing DiffServ class.
no class-map
This command eliminates an existing DiffServ class. The <class-map-name> is the name of
an existing DiffServ class. (The class name ‘default’ is reserved and is not allowed here.) This
command may be issued at any time; if the class is currently referenced by one or more policies or
by any other class, the delete action fails.
Note: The class-map-name 'default' is reserved and must not be used.
Note: The optional keywords [{ipv4 | ipv6}] specify the Layer 3 protocol for this
class. If not specified, this parameter defaults to ‘ipv4’. This maintains
backward compatibility for configurations defined on systems before IPv6 match
items were supported.
Note: The CLI mode is changed to Class-Map Config or Ipv6-Class-Map Config when
this command is successfully executed depending on the [{ipv4 | ipv6}]
keyword specified.
Format class-map match-all <class-map-name> [{ipv4 | ipv6}]
Mode Global Config
Format no class-map <class-map-name>
Mode Global Config