Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-16
v1.0, November 2010
match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask>
parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
match dstip6
This command adds to the specified class definition a match condition based on the destination
IPv6 address of a packet.
match dstl4port
This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation. To specify the match
condition as a single keyword, the value for <portkey> is one of the supported port name
keywords. The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http, smtp,
snmp, telnet, tftp, www. Each of these translates into its equivalent port number. To specify the
match condition using a numeric notation, one layer 4 port number is required. The port number is
an integer from 0 to 65535.
Default none
Format match dstip <ipaddr> <ipmask>
Mode Class-Map Config
Default none
Format match dstip6 <destination-ipv6-prefix/prefix-length>
Mode Ipv6-Class-Map Config
Default none
Format match dstl4port {<portkey> | <0-65535>}
Mode Class-Map Config
Ipv6-Class-Map Config