Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-56
v1.0, November 2010
snmp trap link-status all
This command enables link status traps for all interfaces.
no snmp trap link-status all
This command disables link status traps for all interfaces.
show snmpcommunity
This command displays SNMP community information. Six communities are supported. You can
add, change, or delete communities. The switch does not have to be reset for changes to take
effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through TCP/IP
to an external SNMP manager based on the SNMP configuration (the trap receiver and other
SNMP community parameters).
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 7-52
Format snmp trap link-status all
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 7-52
Format no snmp trap link-status all
Mode Global Config
Format show snmpcommunity
Mode Privileged EXEC