Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Log Messages 8-24
v1.0, November 2010
OS In hapiBroadSystemMacAddress call to
'bcm_l2_addr_add' - FAILED : x
Failed to add an L2 address to the MAC
table. This should only happen when a hash
collision occurs or the table is full.
OS Failed installing mirror action - rest of the
policy applied successfully
A previously configured probe port is not
being used in the policy. The release notes
state that only a single probe port can be
configured
OS Policy x does not contain rule x The rule was not added to the policy due to
a discrepancy in the rule count for this
specific policy . Additionally, the message
can be displayed when an old rule is being
modified, but the old rule is not in the policy
OS ERROR: policy x, tmpPolicy x, size x, data x
x x x x x x x
An issue installing the policy due to a
possible duplicate hash
OS ACL x not found in internal table Attempting to delete a non-existent ACL
OS ACL internal table overflow Attempting to add an ACL to a full table
OS In hapiBroadQosCosQueueConfig, Failed to
configure minimum bandwidth. Available
bandwidth x
Attempting to configure the bandwidth
beyond it’s capabilities
OS USL: failed to put sync response on queue A response to a sync request was not
enqueued. This could indicate that a
previous sync request was received after it
was timed out
OS USL: failed to sync ipmc table on unit=x Either the transport failed or the message
was dropped
OS usl_task_ipmc_msg_send(): failed to send
with x
Either the transport failed or the message
was dropped
OS USL: No available entries in the STG table The Spanning Tree Group table is full in
USL
OS USL: failed to sync stg table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t
exist
OS USL: A Trunk being created by bcmx
already existed in USL
Possible synchronization issue between the
application, hardware, and sync layer
OS USL: A Trunk being destroyed doesn't exist
in USL
Possible synchronization issue between the
application, hardware, and sync layer.
Table 8-52: System General Error Messages
Component Message Cause