Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-47
v1.0, November 2010
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the number
of user configurable queues available for the hardware platform. The assign-queue parameter
is valid only for a permit rule.
The mirror parameter allows the traffic matching this rule to be copied to the specified <unit/
slot/port>, while the redirect parameter allows the traffic matching this rule to be forwarded
to the specified <unit/slot/port>. The assign-queue and redirect parameters are
only valid for a permit rule.
ipv6 traffic-filter
This command either attaches a specific IPv6 ACL identified by <name> to an interface or
associates with a VLAN ID in a given direction. The <name> parameter must be the name of an
existing IPv6 ACL.
An optional sequence number may be specified to indicate the order of this mac access list relative
to other IPv6 access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specifiedIPv6 access list replaces the currently attached IPv6 access list using that sequence
number. If the sequence number is not specified for this command, a sequence number that is one
greater than the highest sequence number currently in use for this interface and direction is used.
This command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the
Global Config mode. The Interface Config mode command is only available on platforms that
support independent per-port class of service queue configuration.
Format {deny | permit} {every | {{icmp | igmp | ipv6 | tcp | udp |
<number>}[log] [assign-queue <queue-id>] [{mirror | redirect} <unit/
slot/port>]
Mode IPv6-Access-List Config
Note: You should be aware that the <out> option may or may not be available,
depending on the platform.