Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-45
v1.0, November 2010
IPv6 Access Control List (ACL) Commands
This section describes the commands you use to configure IPv6 ACL settings. IPv6 ACLs ensure
that only authorized users have access to specific resources and block any unwarranted attempts to
reach network resources.
The following rules apply to IPv6 ACLs:
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per IPv6 ACL is hardware dependent.
ipv6 access-list
This command creates an IPv6 Access Control List (ACL) identified by <name>, consisting of
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a case-
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access list.
If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config mode to
allow updating the existing IPv6 ACL.
ACL ID Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access
list.
Sequence
Number
An optional sequence number may be specified to indicate the order of this access list
relative to other access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified access list replaces the currently attached access list
using that sequence number. If the sequence number is not specified by the user, a
sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used. Valid range is (1 to 4294967295).
Note: The CLI mode changes to IPv6-Access-List Config mode when you successfully
execute this command.
Format ipv6 access-list <name>
Mode Global Config
Term Definition