Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Utility Commands 6-42
v1.0, November 2010
no default-router
This command removes the default router list.
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
no dns-server
This command removes the DNS Server list.
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the MAC
address of the hardware platform of the client consisting of 6 bytes in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Format no default-router
Mode DHCP Pool Config
Default none
Format dns-server <address1> [<address2>....<address8>]
Mode DHCP Pool Config
Format no dns-server
Mode DHCP Pool Config
Default ethernet
Format hardware-address <hardwareaddress> <type>
Mode DHCP Pool Config