Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-52
v1.0, November 2010
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled. See “snmp trap link-
status” on page 7-55
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
no snmp-server enable traps multiusers
This command disables Multiple User traps.
Note: This command may not be available on all platforms.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
Format no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config
Format no snmp-server enable traps multiusers
Mode Global Config