Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-45
v1.0, November 2010
no aaa authentication enable
Use this command to remove the authentication method.
aaa authentication dot1x
This command is used to set authentication for dot1x users. The method argument identifies the
list of methods that the authentication algorithm tries, in the given sequence. The additional
methods of authentication are used only if the previous method returns an error, not if there is an
authentication failure. To ensure that the authentication succeeds even if all methods return an
error, specify
none as the final method in the command line. For example if none is specified as
an authentication method after radius, no authentication is used if the radius server is down.
method1 [method2…] At least one from the following table:
Note: If the default list is not set, only the enable password is checked. This has the same
effect as the following command:
aaa authentication enable default enable
On the console, the enable password is used if it exists. If no password is set, the
process will succeed anyway. This has the same effect as the following command:
aaa authentication enable default enable none
Format no aaa authentication enable {default | list-name} method1
[method2...]
Mode Global Config
Format aaa authentication dot1x default method1 [method2...]
Mode Global Config
Keyword Description
local Uses the local username database for authentication.
none Uses no authentication.
radius Uses the list of all RADIUS servers for authentication.
ias Uses the internal authentication server users database for authentication.