Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-55
v1.0, November 2010
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
snmp trap link-status
This command enables link status traps by interface.
no snmp trap link-status
This command disables link status traps by interface.
Format snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode Global Config
Format no snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 7-52
Format snmp trap link-status
Mode Interface Config
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format no snmp trap link-status
Mode Interface Config