Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-54
v1.0, November 2010
switchport protected (Global Config)
Use this command to create a protected port group. The <groupid> parameter identifies the set
of protected ports. Use the name <name> pair to assign a name to the protected port group. The
name can be up to 32 alphanumeric characters long, including blanks. The default is blank.
no switchport protected (Global Config)
Use this command to remove a protected port group. The groupid parameter identifies the set of
protected ports. Use the name keyword to remove the name from the group.
switchport protected (Interface Config)
Use this command to add an interface to a protected port group. The <groupid> parameter
identifies the set of protected ports to which this interface is assigned. You can only configure an
interface as protected in one group.
Note: Port protection occurs within a single switch. Protected port configuration does not
affect traffic between ports on two different switches. No traffic forwarding is
possible between two protected ports.
Format switchport protected <groupid> name <name>
Mode Global Config
Format NO switchport protected <groupid> name
Mode Global Config
Note: Port protection occurs within a single switch. Protected port configuration does not
affect traffic between ports on two different switches. No traffic forwarding is
possible between two protected ports.
Default unprotected