Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-58
v1.0, November 2010
show private-group
This command displays the private groups’ information.
GARP Commands
This section describes the commands you use to configure Generic Attribute Registration Protocol
(GARP) and view GARP status. The commands in this section affect both GARP VLAN
Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). GARP is a
protocol that allows client stations to register with the switch for membership in VLANS (by using
GVMP) or multicast groups (by using GVMP).
set garp timer join
This command sets the GVRP join time for one port (Interface Config mode) or all (Global Config
mode) and per GARP. Join time is the interval between the transmission of GARP Protocol Data
Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group. This
command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds).
The value 20 centiseconds is 0.2 seconds.
Format show private-groupname [<private-group-name>|<private-group-
id>|port <unit/slot/port>]
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Port VLANID
The VLAN ID associated with the port.
Private Group
ID
Total number of private groups is 192.
Private Group
Name
The name string can be up to 24 bytes of non-blank characters
Private Group The mode can be either “isolated” or “community”.