Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-129
v1.0, November 2010
Example: The following shows example CLI display output for the command.
(switch) #show ip dhcp snooping
DHCP snooping is Disabled
DHCP snooping source MAC verification is enabled
DHCP snooping is enabled on the following VLANs:
11 - 30, 40
Interface Trusted Log Invalid Pkts
--------- -------- ----------------
0/1 Yes No
0/2 No Yes
0/3 No Yes
0/4 No No
0/6 No No
show ip dhcp snooping binding
Use this command to display the DHCP Snooping binding entries. To restrict the output, use the
following options:
• Dynamic: Restrict the output based on DCHP snooping.
• Interface: Restrict the output based on a specific interface.
• Static: Restrict the output based on static entries.
• VLAN: Restrict the output based on VLAN.
Format show ip dhcp snooping binding [{static/dynamic}] [interface unit/
slot/port] [vlan id]
Mode • Privileged EXEC
• User EXEC
Term Definition
MAC Address Displays the MAC address for the binding that was added. The MAC address is the key
to the binding database.
IP Address Displays the valid IP address for the binding rule.
VLAN The VLAN for the binding rule.
Interface The interface to add a binding into the DHCP snooping interface.