Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Utility Commands 6-40
v1.0, November 2010
DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the switch.
DHCP uses UDP as its transport protocol and supports a number of features that facilitate in
administration address allocations.
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP pool
configuration mode.
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured pool
name.
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the
media type and the MAC address. For example, the Microsoft client identifier for Ethernet address
c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more
information, refer to the “Address Resolution Protocol Parameters” section of RFC 1700,
Assigned Numbers for a list of media type codes.
Default none
Format ip dhcp pool <name>
Mode Global Config
Format no ip dhcp pool <name>
Mode Global Config
Default none
Format client-identifier <uniqueidentifier>
Mode DHCP Pool Config