Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-145
v1.0, November 2010
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface or all
interfaces. The Group Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The
range is 2 to 3600 seconds.
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular interface
or VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait
after sending a query on an interface because it did not receive a report for a particular group in
that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to
25 seconds.
Default 260 seconds
Format set igmp groupmembership-interval <2-3600>
Mode • Interface Config
• Global Config
Format set igmp groupmembership-interval <vlan_id> <2-3600>
Mode VLAN Config
Format no set igmp groupmembership-interval
Mode • Interface Config
• Global Config
Format no set igmp groupmembership-interval <vlan_id>
Mode VLAN Config
Default 10 seconds