Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-86
v1.0, November 2010
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadcast storm recovery.
storm-control multicast
This command enables multicast storm recovery mode for an interface. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format storm-control broadcast rate <0-14880000>
Mode Global Config
Format no storm-control broadcast rate
Mode Global Config
Default disabled
Format storm-control multicast
Mode Interface Config
Format no storm-control multicast
Mode Interface Config